Case studies

A card box whose lid closes itself

A box for a deck of cards with a hinged lid that falls shut on its own and snaps closed on magnets. The hinge has a built-in stop, so the lid never opens past the angle where gravity can still close it. The lettering inlays in a second colour, and both parts print without supports.

Multi-part designPause for magnetsFonts from your MacAssembly stepsPrinter fits

Options

Corner style, fonts and inlaid or engraved lettering are menus.

Two ways to make it yours

Ask your AI agent, or change it yourself in the editor. Here's what each looks like for this design.

With your AI agent

Make a box for a deck of poker cards with a hinged lid that closes by itself and stays shut with two 6 × 2 mm magnets. Put “Poker Night” on the front.

Your agent works through ScadBox's tools, for example:

  1. get_hardware gets the magnet's real size and the pocket clearance
  2. list_fonts · preview_fonts picks a font that's on your Mac and prints cleanly
  3. render · section cuts through the hinge to check the stop and the lid's clearance
  4. pause_plan finds the layer to pause at to drop the magnets in
  5. assembly_instructions magnets, hinge pin, cards

Then keep going in plain words:

Make it hold two decks side by side.

In the editor

  1. Change the text: the words, fonts and suit symbols are customizer fields
  2. Pick a finish: inlaid or engraved lettering; round, chamfered or square corners
  3. Tune the fit: the press fit comes from your printer profile, or nudge it with a slider

Assembly

Press the magnets in at the pause, fit the hinge pin, add the cards.