Case studies

A coin bank that proves it prints

A coin bank printed in one piece, with a slot on top and a plug underneath. Its inside ceiling can't be reached once it's printed, so it mustn't need supports. With a peaked roof it doesn't; switch to a flat roof and Print Check shows support trapped inside, reachable only through the slot.

Print Check (Pro)Supports you can't removeAssembly steps

Print Check finds the problem

With a flat roof, Print Check colours the support under it red: it would be trapped inside.

Two ways to make it yours

Ask your AI agent, or change it yourself in the editor. Here's what each looks like for this design.

With your AI agent

Design a house-shaped coin bank that prints in one piece with a slot on top and a plug underneath. Nothing inside should need supports, because I can't get them out.

Your agent works through ScadBox's tools, for example:

  1. render · snapshot builds the house and the plug
  2. supports finds where support would go, and whether it could be removed
  3. section cuts it open to look at the inside ceiling
  4. export bank and plug, ready to print

Then keep going in plain words:

What happens if the roof is flat?

In the editor

  1. Try a flat roof: switch roof to flat, turn on Print Check, and see the trapped support in red (Pro)
  2. Size it: every size is a slider
  3. Fit the plug: the press fit comes from your printer profile

Peaked or flat

Assembly